I began pulling out the rotted wood and un-salvageable parts of The COMET.
This post will be most useful to those of you who are thinking about (or in the process of) restoring/re-doing a vintage camper. Here are some of the "fun" things you might find when working on a camper that is over 50 years old!
Here's the rear wall panel. As you can see, there is visible dry rot and water damage under the window. I took off the window frame and decided I need to replace the wood from half way down the window and below (imagine a straight horizontal line continuing off of both sides of the window where the gap in the panes are - everything below that).
I began going at it with a chisel before deciding that the job needs a more precise hand held multitool, something like the Rockwell SonicCrafter, which can cut flush up again the walls. I peaked behind the wall panel, and all of the wood back there looks great, no damage.
(Disclaimer: some of these links are affiliate links, meaning that at no extra cost to you, if you decide to purchase something I recommend I get a small commission, which helps keep this blog up and running! Thank you!)
I'm still going to super reinforce the framing of this wall with more beams though, because I'll want the extra supports when I go to mount the bumper greenhouse later.
This is a photo of underneathone of the front dinette benches, where the original water tank was. The water tank was a big hunk of rusty metal, so I used a sawzall to cut it out of the wall and then pulled it out.
You can see that this area once kept a mouse very warm! I'm going to clean this area up and put down some new wood, maybe paint it all white so that you can see it better, then have the new water tank (which I ordered yesterday from Timbucktu RV in MA) installed in here. I don't know why there's an outlet in this box, but we'll find out!
Here's where I tore out the old camper toilet. Kinda gross! I'm going to try to re-use the tiny camper toilet seat from the original toilet, since it's so small and perfect sized for the tiny closet.
You can see that the toilet closet is a step up from the rest of the floor of the camper. I think I'm going to saw through the floor of the toilet closet and replace it with one that is at the same level as the rest of the camper.
It's probably a little higher right now to make room for a black water tank and plumbing, but the composting toilet doesn't require a tank or any plumbing for water, so it doesn't have to be a step up like that. Can't wait to take out the floor and see what's lurking under there... Can't wait to show you all the mock-up for the squatting composting toilet.
Here's the 30 amp/120V AC inlet that is on the exterior wall of the COMET. The male inlet is missing, so I got a whole new assembly (Thank You TIMBUCKTU RV!!). This is just temporary, so that I can use the lights and outlets in the camper, until the PV system is installed.
It's been pouring rain the yesterday and today, so I'm hoping it lets up soon so I can get back to work! Someday I'll have an indoor workshop and won't have to rely on good weather. I've been collecting all of the materials I will need for the first few repairs (hardware, electrical, wood) so I won't run into any unexpected roadblocks.